3D Printed Crafts: The Mooninites
I’ve been away from my place for a good chunk of this month and when I haven’t been away, I’ve still been terribly busy. But since I started this blog over two years ago, I’ve managed to post at least one update a month even at my busiest and I’m not going to let that streak end now. So here’s a 3D printed craft that I recently made for my brother and held off on doing a write-up for until now. He initially wanted two sets of Mooninites from Aqua Teen Hunger Force and I was more than happy to oblige. The first thing I did was hop on over to Cults3D and download a free model of Ignignokt and Err, which I set up in my slicer program and printed in PLA filament using my Prusa MK3S+ FDM printer. The next order of business was to sand and surface the prints to get rid of as much of the visible 3D printer layer lines as I could. I used some gray Rustoleum sandable filler primer, then followed it up with a round of sanding using a dollar store sanding sponge as well as some thinner sand